Hitec MD250MW 8kg

Hitec Servo MD250MW

15mm extra class!

A servo in the standard size cannot always be built in, and the 12-13 mm servos, on the other hand, are not strong and robust enough.
The solution, a 15mm servo that delivers enough power and is still very light.

In addition to the well-known D-series technology, which makes the servo fully programmable (details below),
this servo also comes with a magnetic encoder.
Ie contactless position recording, absolutely wear-free, infinite service life and extremely precise!

What more do you need?
A full metal housing that only makes the servo heavier but not more robust, certainly not.
The MD250MW can be used from 4.8 to 8.4 volts and is therefore ideally suited for mid-range helicopters, but best for surface models where power and a quick response from the rudder is required. This servo is preferably used as a wing servo for large sailors.
And with a force of ~ 9.1kgcm at 8.4 volts, it has a lot of power!

Magnetic encoder / Hall sensor
• Best available servo travel resolution.
• Finest response
• Programmable
• High actuating force
• Excellent holding force
• Metal gear
• 2 ball bearings MR106 / MR85
• 25 toothing for servo horn

Setting the end point (0 ° -180 °), neutral (standard ± 60 °)
• Setting the direction of rotation (clockwise / counterclockwise)
• Setting the dead zone
• Setting the speed (standard 100%)
• Setting Soft Start (standard 20%)
• Setting the fail-safe function
• Setting the overload protection (standard off)
• Factory settings can be restored

1x fastening set (screws, eyes and rubber grommets)
1x servo lever (disc) M-O25 mounted
1x servo lever metal R-ML25 (order number 118719)
1x servo lever M-I25
1x servo lever (cross) M- X25
1x instructions

Width : 15 mm
Height : 33 mm
Length : 35 mm
Weight : 0.039 kg
Servo type: Standard
Special features: Wide-Voltage-Digital
Motor type Servos: brushed
Gear: Metal
Operating voltage in V: 4.8-8.4 V
Operating time s / 60 ° at 4.8 volts: 0.2
actuating time s / 60 ° at 6.0 volts: 0.16
actuating time s / 60 ° at 7.4 volts: 0.13
torque in kgcm at 4.8 volts: 5
torque in kgcm at 6.0 Volts: 6
torque in kgcm at 7.4 volts: 8
teeth: 25T
Ball bearings: Yes
Waterproof: No
Brief description of servo: Magnetic encoder, maxiamler angle of rotation 180 °
Recommendation for flight: Yes
Recommendation helicopter: Yes
Recommendation car: Yes
Recommendation boat: Yes